Read all enclosed instructions
carefully before use. The LaserComb should be used on a “clean scalp” after
shampooing either slightly wet or dried. It should be used before applying
any other topical treatments, gels or sprays.
- Insert the power attachment into the
LaserComb. Plug in the wall adaptor.
- Turn on the LaserComb by first switching
on the “Power” button and the “Laser” button.
- Place the LaserComb flat on your scalp
using the 2 rows of teeth.
- Move the LaserComb using a “Glide”
method by placing the LaserComb on a spot and leaving it there for 4
seconds then moving it 1/2 inch to the next spot (mentally counting “one
thousand, two thousand, etc.” should help with timing).
- Comb against the direction of the hair
growth. With long hair, use an ordinary comb to lift the hair in advance
of the LaserComb.
- Make 2 complete passes with the
LaserComb over the whole scalp area in the manner described above.
- After treatment turn off both buttons
and remove the wall plug.
1.
The total time it should take
will range between 10-15 minutes.
2.
It is essential to move the
LaserComb very slowly because if you move it too fast, the treatment will
not be as effective.
3.
Do not overuse the LaserComb, as
additional usage may be actually less effective (as the scalp becomes “too
used to the treatment”).
4. Do not stare at the laser light.
5. Do not stare at the laser light reflected
from any reflective surface or shine the laser in or around your eyes.
6. Keep out of reach of children. Do
not allow minors to use lasers.
7. Never shine a laser at anyone.
8. Do not point a laser at mirror-like
surfaces. A reflected beam can act like a direct beam on the eye.
9. The use of magnifying optical instruments
with this product can cause eye danger.
10. Do not attempt to repair, enter, alter,
or interfere in any way with the workings of this appliance or any part of
this appliance.
11. Use controls and performance procedures
only at those specified herein.
